T3000ei

• NEVER allow an untrained person to operate the Terminator
• NEVER allow anyone to stand directly behind the Terminator
• NEVER drive over debris piles as it can tip the machine

INCLINES:

• Use extreme caution when operating on slight inclines
• NEVER operate this machine on steep inclines
• NEVER try to turn the machine around on an incline
• NEVER reverse the machine down an incline

LOADING and UNLOADING into a trailer:

• Always use extreme caution
• Use the travel dolly with the wheels locked so they only roll forward/reverse for better control
• Load the machine by driving FWD or REV UP the ramp
• Unload the machine by driving FORWARD DOWN the ramp
• NEVER reverse the machine down the ramp

• Only allow trained operators to operate the Terminator
• For effective flooring removal, have a variety of tooling options onsite
• Wear all required PPE
• All safety panels, hood and footboard are securely in place
• Amber warning light and backup alarm are working correctly
• Check battery pack to ensure it is fully charged
• Engage forward and reverse levers and jaw lever to ensure they are operating freely
• Check for hydraulic leaks, tighten fittings if necessary
• Check cable connections on the batteries to ensure tightness (weekly)
• Check levels on wet-cell batteries. Add distilled water to keep at ¼” above plates (if applicable, every two weeks)

• For effective flooring removal, have a variety of tooling options onsite.
• If the machine struggles to remove material, try narrower tooling. The guideline is: the harder the material is to remove, the narrower the tooling must be in order to be effective.
• Always insert tool fitting completely, so the metal ring on the fitting and the metal ring of the jaw meet. Then insert the keeper pin in either the front or rear mounting point to secure tooling in place.
• Watch the video below for an overview of the TOOLING available for the T3000E1